Honda 2004 Odyssey, Service Manual

Page: 2210 / 2459

−
−
−
−
−
０１
０１
Ｓ０Ｘ４ＡＺ３Ｋ７９１０００８１０９３ＦＡＡＴ００
’02 Model
DTC 9-3:
YES
NO
YES
NO
23-145
B
A
DRIVER’S SEAT BELT BUCKLE SWITCH
3P CONNECTOR
BLU/RED BLK
BLK
RED/BLU
Faulty Driver’s Seat Belt Buckle
Switch
1. Erase the DTC memory (see page 23-38).
2. Turn the ignition switch ON (II), then buckle and
unbuckle the driver’s seat belt several times.
3. Read the DTC (see page 23-35).
Go to step 4.
Intermittent failure, system is OK at this time.
Go to Troubleshooting Intermittent Failures (see
page 23-39).
4. Turn the ignition switch OFF.
5. Disconnect the left side wire harness 3P connector
(A) from the driver’s seat belt buckle switch 3P
connector (B).
6. Buckle the driver’s seat belt.
• Check resistance between the No. 1 and No. 3
terminals of the driver’s seat belt buckle switch
3P connector. There should be 0
1 .
• Check resistance between the No. 1 and No. 2
terminals of the same connector. There should
be an open circuit, or at least 1 M
.
Go to step 7.
Replace the driver’s seat belt buckle assembly,
and clear the DTC.
(cont’d)
Terminal side of male terminals
Terminal side of male terminals
Is DT C 9-3 indicated?
Ar e the r esistance r eadings as specif ied?
03/07/29 10:34:54 61S0X050_230_0145