Honda 2004 Odyssey, Service Manual

Page: 405 / 2459

−
−
−
−
−
−
−
−
−
−
−
０１
０２
０３
Ｓ０Ｘ４ＡＺ１Ｋ７７１０００９０１０７ＦＡＡＴ００
DTC P0107 ’01 Model:
YES
NO
YES
NO
YES
NO
YES
NO
YES
NO
11-96
PGM-FI System
DTC Troubleshooting (cont’d)
MAP SENSOR 3P CONNECTOR
VCC1
(YEL/RED)
SG1
(GRN/WHT)
PCM CONNECTOR A (31P)
SG1
(GRN/WHT)
VCC1
(YEL/RED)
MAP SENSOR 3P CONNECTOR
MAP (RED/GRN)
MAP Sensor Circuit
Low Voltage
1. Turn the ignition switch ON (II).
2. Check the MAP with the scan tool or the HDS.
Intermittent failure, system is OK at this time.
Check for poor connections or loose terminals at
the MAP sensor and the PCM.
Go to step 3.
3. Turn the ignition switch OFF.
4. Disconnect the MAP sensor 3P connector.
5. Turn the ignition switch ON (II).
6. Measure voltage between MAP sensor 3P
connector terminals No. 1 and No. 3.
Go to step 8.
Go to step 7.
7. Measure voltage between PCM connector
terminals A29 and A31.
Repair open in the wire between the PCM
(A31) and the MAP sensor.
Substitute a known-good PCM and recheck
(see page 11-5). If normal MAP readings are
indicated, replace the original PCM.
8. Check the MAP with the scan tool or the HDS.
Go to step 9.
Replace the MAP sensor.
9. Turn the ignition switch OFF.
10. Disconnect PCM connector A (31P).
11. Check for continuity between MAP sensor
connector terminal No. 2 and body ground.
Repair short in the wire between the PCM
(A27) and the MAP sensor.
Substitute a known-good PCM and recheck
(see page 11-5). If normal MAP readings are
indicated, replace the original PCM.
Wire side of female terminals
Wire side of female terminals
Wire side of female terminals
Is about 101 kPa ( 7 60 mmHg, 30 in.Hg), or 2.9 V
indicated?
Is ther e about 5 V ?
Is ther e about 5 V ?
Is about 2 kPa ( 15 mmHg, 0.6 in.Hg), 0.5 V or less
indicated?
Is ther e continuity?
03/07/29 09:19:51 61S0X050_110_0096