Honda 2004 Odyssey, Service Manual

Page: 2455 / 2459

０１
０２
Ｓ０Ｘ４ＡＺＢＨ４６４０００５３７９５ＫＢＡＴ００
Removal (’03-04 Models) Installation (’03-04 Models)
23-390
SRS
Front Passenger’s Weight Sensor Replacement
A
B
32 N·m
(3.3 kgf·m,
24 lbf·ft)
A
NOTE:
• Removal of the front passenger’s weight sensors
must be performed according to the precautions/
procedures described at the beginning of this section.
• Before disconnecting the front passenger’s weight
sensors connectors, disconnect the front passenger’s
airbag 4P connector..
• Do not turn the ignition switch ON (II), and do not
connect the battery cable while replacing the front
passenger’s weight sensors.
1. Disconnect the battery negative cable, and wait at
least 3 minutes before beginning work.
2. Remove the seat assembly (see page 20-81) and
seat riser (see page 20-99).
3. Disconnect the front passenger’s weight sensors
connectors from the seat weight sensor unit (see
page 23-391).
4. Remove the harness clips and mounting nuts (A),
then remove the front passenger’s weight sensors
(B) from the seat riser.
NOTE:
• Be sure to install the harness wires so they are not
pinched or interfering with other parts.
• Do not turn the ignition switch ON (II), and do not
connect the battery cable while replacing the front
passenger’s weight sensors.
• Tighten the mounting nuts from the backside.
Improper tightening could cause the airbag system to
accidentally deploy, causing damage or injuries.
1. Place the new front passenger’s weight sensors on
the seat riser. Tighten the mounting nuts (A) from
the backside and connect the sensor connectors to
the front passenger’s weight sensors unit. Then
install the harness clips.
2. Install the seat riser (see page 20-99) and the seat
assembly (see page 20-81).
3. Reconnect the battery negative cable.
4. Calibrate the front passenger’s weight sensors unit
(see page 23-42).
5. After installing the front passenger’s weight
sensors, confirm proper system operation: Turn the
ignition switch ON (II): the SRS indicator should
come on for about 6 seconds and then go off.
03/07/29 10:42:59 61S0X050_230_0390