Honda 2004 Odyssey, Service Manual

Page: 775 / 2459

０１
０１
０３
Ｓ０Ｘ４ＡＡ０Ｅ１０４１１４１２２８１ＭＢＡＴ００
14-162
Automatic Transmission
Shift Cable Adjustment
D
B
A
G
E
C
F
A
B
C
SRS components are located in this area. Review the
SRS component locations (see page 23-18), and the
precautions and procedures (see page 23-21) in the SRS
before performing repairs or service.
1. Remove the steering column covers (see page 17-
25).
2. Shift the transmission into the N position.
3. Remove the nut (A) securing the shift cable end (B),
then separate the shift cable (C) from the shift lever
assembly (D).
4. Rotate the socket holder (E) on the shift cable
counterclockwise a quarter turn, then slide the
holder to remove the shift cable from the shift cable
bracket (F).
NOTE: Do not remove the shift cable by twisting
the shift cable guide (G).
5. Push the shift cable until it stops, then release it.
Pull the shift cable back two steps so that the shift
lever position is in the N.
6. Turn the ignition switch ON (II), and verify that the
N position indicator comes on.
7. Turn the ignition switch OFF.
8. Insert a 6.0 mm (0.24 in.) pin (A) through the
positioning hole (B) on the detent plate and into the
positioning hole (C) on the control bracket.
03/07/29 09:33:58 61S0X050_140_0165