Honda 2004 Odyssey, Service Manual

Page: 1261 / 2459

＋
＋
−
−
−
−
−
−
＋ ＋ ＋ ＋
＋ ＋ ＋ ＋
＋ ＋ ＋ ＋
＋ ＋ ＋ ＋
Ｓ０Ｘ４Ａ０７Ｋ７０１０００８１２１０ＦＡＡＴ００
DTC Other Terminal
YES
NO
YES
NO
DTC Appropriate Pulser
YES
NO
Appropriate
Terminal
DTC 21, 22, 23, 24:
19-60 19-60
ABS Components
DTC Troubleshooting (cont’d)
4. Check for continuity between the appropriate
wheel sensor ( ) circuit terminal and other wheel
sensor ( ) circuit terminals (see table).
12
14
16
18
Repair a short in the wires between the
appropriate wheel sensor and the other wheel
sensor.
Clear the DTC, and test-drive the vehicle. If
the ABS indicator comes on and the same DTC is
indicated, replace the ABS control unit.
1. Clear the DTC (see step 1 on page 19-43).
2. Test-drive the vehicle at 19 mph (30 km/h) or more.
Go to step 3.
The system is OK at this time.
3. Check the appropriate pulser gears for a chipped
tooth (see table).
21 Right-front
22 Left-front
23 Right-rear
24 Left-rear
Check for loose terminals in the ABS control
unit connectors. If necessary, substitute a known-
good ABS control unit, and recheck.
Replace the driveshaft or the hub unit with the
chipped tooth on the pulser gear.
No. 9:
FRW ( )
No. 7:
FLW ( )
No. 19:
RRW ( )
No. 17:
RLW ( )
No. 7:
FLW ( )
No. 9:
FRW ( )
No. 19:
RRW ( )
No. 17:
RLW ( )
No. 19:
RRW ( )
No. 9:
FRW ( )
No. 7:
FLW ( )
No. 17:
RLW ( )
No. 17:
RLW ( )
No. 9:
FRW ( )
No. 7:
FLW ( )
No. 19:
RRW ( )
Pulser
Is ther e continuity?
Does the ABS indicator come on and ar e DT Cs 21,
22, 23, 24 indicated?
Ar e the pulser gear s OK ?
03/07/29 09:55:47 61S0X050_190_0060