Honda 2004 Odyssey, Service Manual

Page: 2388 / 2459

−
−
−
−
０１
０２
０３
Ｓ０Ｘ４ＡＺＢＫ７９１０００Ｒ９１２ＸＦＡＡＴ００
’03-04 Models
DTC 91-2x (91-20 to 91-29, 91-2A to 91-2F):
YES
NO
YES
NO
23-323
A
C
SRS UNIT CONNECTOR A (28P)
BLU
Short in SRS Indicator Circuit
1. Erase the DTC memory (see page 23-39).
2. Turn the ignition switch ON (II), and check that the
SRS indicator comes on for about 6 seconds and
then goes off.
Go to step 3.
Intermittent failure, system is OK at this time.
Go to Troubleshooting Intermittent Failures (see
page 23-39).
3. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
4. Disconnect SRS unit connector A (28P) from the
SRS unit.
5. Remove the gauge assembly (see page 22-100).
Disconnect gauge assembly connector C (16P) from
the gauge assembly.
6. Check resistance between the No. 19 terminal of
SRS unit connector A (28P) and body ground. There
should be an open circuit, or at least 1 M
.
Go to step 11.
Go to step 7.
(cont’d)
Wire side of female terminals
Does the SRS indicator stay on?
Is the r esistance as specif ied?
03/07/29 10:41:14 61S0X050_230_0323