Honda 2004 Odyssey, Service Manual

Page: 1143 / 2459

０１
０１
Ｓ０Ｘ４Ａ００Ｆ００００００５７１６１ＫＣＡＴ００
17-24
Power Steering
Steering Wheel Installation
A B
B
A
D
C
1. Before installing the steering wheel, make sure the
front wheels are aligned straight ahead, then center
the cable reel (A). Do this by first rotating the cable
reel clockwise until it stops. Then rotate it
counterclockwise about two and half turns. The
arrow mark (B) on the cable reel should point
straight up.
2. Position the two tabs (A) of the turn signal
canceling sleeve (B) as shown, and install the
steering wheel on to the steering column shaft,
making sure the steering wheel hub (C) engages
the pins (D) of the cable reel and tabs of the
canceling sleeve. Do not tap on the steering wheel
or steering column shaft when installing the
steering wheel.
3. For ’99-01 models; install a new steering wheel nut,
and tighten it to 49 N·m (5.0 kgf·m, 36 lbf·ft).
4. For ’02-04 models; install a new steering wheel bolt,
and tighten it to 38 N·m (3.9 kgf·m, 28 lbf·ft).
5. Connect the radio remote switches connector and
cruise control switch connector.
6. Install the driver’s airbag, and confirm that the
system is operating properly (see page 23-369).
7. Check the horn, radio remote switch, cruise control
set/resume switch and turn signal canceling switch
for proper operation.
8. Reconnect the battery and do the following.
• Power window control unit resetting procedure
(see page 22-200).
• PCM idle learn procedure (see page 11-202).
• Set the clock.
• Enter the radio anti-theft code.
• Enter the navigation system anti-theft code.
03/07/29 09:49:05 61S0X050_170_0024