background image

PCM3CAM

NTV-KIT100

Rev 

2

  

BHM 03/18/15

NTV-DOC045

3950  NW  120th  Ave

,

  Coral  Springs,

  FL  33432   

Tel.  561-955-9770              Fax.  561-955-9760

 

www.nav-tv.com

 

[email protected]

 

PCM3CAM-USB 

F

ront and rear camera interface 

 Enables a backup camera and a secondary on the factory 2009 and Up Porsche PCM 3.0 Radios 

Certain features are intended for passenger and off-road use only. User must obey 
all State and Federal regulations 

Make sure your radio looks like this prior to installation 

Kit Contents

 

1 | 

P a g e

Filter Harness Description and Diagram 

Wire Functions 

Wire Colors 

Fig. 2 - Connection plug on Can Filter 

1. CAN Hi to Vehicle.
2. CAN Lo to Vehicle
3. Chassis Ground.
4. +12V Output to Camera.
5. CAN Hi to PCM.
6. CAN Lo to PCM.
7. +12V Battery
8. +12V Output to switcher and front Flir IR camera.

1. Yellow
2. Blue
3. Black
4. White/Red
5. Yellow
6. Blue
7. Red
8. White/Blue

8 pin Molex connector 

Wire side view 

PCM3-CAM Module

NTV-ASY

107

Plug & Play Harness

NTV-HAR

111

USB Cable (Updates)

NTV-CAB009

VSW-R Harness

NTV-

HAR

301

VSW-R Trigger 

Harness

NTV-

HAR066

VSW-R Board

NTV-

ASY187

V1 Switcher shown

here, this has been

replaced with the

VSW-R in 03/15

Summary of Contents for PCM3CAM

Page 1: ...tallation Kit Contents 1 P a g e Filter Harness Description and Diagram Wire Functions Wire Colors Fig 2 Connection plug on Can Filter 1 CAN Hi to Vehicle 2 CAN Lo to Vehicle 3 Chassis Ground 4 12V Output to Camera 5 CAN Hi to PCM 6 CAN Lo to PCM 7 12V Battery 8 12V Output to switcher and front Flir IR camera 1 Yellow 2 Blue 3 Black 4 White Red 5 Yellow 6 Blue 7 Red 8 White Blue 8 pin Molex connec...

Page 2: ...y out of the dash in order to disconnect all stock cables and antenna connectors 3 View of rear of radio and stock radio harness Remove the fiber optic connector from the original harness by gently prying up on the locking tab with a pick tool 4 With the fiber unplugged from the factory harness plug the aftermarket harness into the original harness and secure it by closing the stock locking tab At...

Page 3: ...ht vision camera RCA into Video 2 in Connect the black ground wire from step 5 to both the ground of the front camera and the ground black wire from the video switcher Connect the 12v wire Video 2 Trig of the switcher white red wire to the white blue wire from the module Vehicles without factory camera switcher installation 7b Extend and plug the female RCA radio side of the harness into Video Out...

Page 4: ... in reverse and your image will appear on the screen When putting the vehicle back in drive the image will stay on the screen for up to 20 seconds or until the vehicle reaches 7 mph 2 To enable the rear view camera while in motions simply double click the mute button within 1 second To deactivate the camera while in motion double click the mute button again 3 It the switcher is used to switch betw...

Reviews: