Honda 2004 Odyssey, Service Manual

Page: 798 / 2459

＊０１
Ｓ０Ｘ４ＡＡ０Ｅ１０４３６４３６００１ＦＥＡＴ００
０１
Ｓ０Ｘ４ＡＡ０Ｅ１０４３６４５５１０１ＦＥＡＴ００
14-185 14-185
Key Interlock Solenoid/Switch Test Shift Lock Solenoid Test
KEY SWITCH CONNECTOR (7P)
SRS components are located in this area. Review the
SRS component locations (see page 23-18), and the
precautions and procedures (see page 23-21) in the SRS
before performing repairs or service.
1. Remove the steering lower cover (see page 17-25).
2. Disconnect the key switch connector (7P) from the
steering lock assembly.
3. Check for continuity between the No. 5 and No. 7
terminals when the key is pushed, and check for no
continuity when the key is released.
4. Check that the key cannot be removed with power
connected to the No. 7 terminal and ground
connected to the No. 3 terminals.
• If the key cannot be removed, the key interlock
solenoid is OK.
• If the key can be removed, replace the steering
lock assembly (the key interlock solenoid is not
available separately).
SRS components are located in this area. Review the
SRS component locations (see page 23-18), and the
precautions and procedures (see page 23-21) in the SRS
before performing repairs or service.
1. Remove the steering column upper cover (see page
17-25).
2. Disconnect the shift lock solenoid 2P connector.
3. Connect the No. 1 terminal of the shift lock solenoid
connector to the battery positive terminal, and
connect the No. 2 terminal to the battery negative
terminal.
4. Check that the shift lever can be moved from the P
position. Release the battery terminals from the
shift lock solenoid connector. Move the shift lever
back to the P position, and make sure it locks.
NOTE: Do not connect power to the No. 2 terminal
(reverse polarity) or you will damage the diode
inside the solenoid.
5. Check that the shift lock releases when the release
lever is pushed, and check that it locks when the
release lever is released.
6. If the solenoid does not work, replace it.
Terminal side of male terminals
03/07/29 09:34:15 61S0X050_140_0188