Honda 2004 Odyssey, Service Manual

Page: 2405 / 2459

−
−
−
−
−
−
０８
Ｓ０Ｘ４ＡＺ４Ｈ４６４０００５６６０２ＦＡＡＴ０１
’99-01 Models
SRS indicator stays on when in ‘‘SCS’’ menu
method
YES
NO
YES
NO
YES
NO
23-340
SRS
Symptom Troubleshooting (cont’d)
A
B
C
NOTE:
• If you cannot retrieve DTCs with the HDS using the
SRS menu method, retrieve the flash codes with the
Tester in SCS mode (see page 23-36).
• A new SRS unit must sense the entire system is OK
before completing its initial self-test. The most
common cause of an incomplete self-test is the
failure to replace all deployed parts after a collision,
in particular, seat belt tensioners.
• An incomplete self-test prevents the HDS from
retrieving DTCs, although flash codes are available in
the Tester’s SCS mode.
1. Erase the DTC memory by ‘‘SCS’’ menu method
(see page 23-38).
Go to step 37.
Go to step 2.
2. Check the No. 2 (10A) fuse in the driver’s under-
dash fuse/relay box.
Go to step 17.
Go to step 3.
3. Replace the No. 2 (10A) fuse in the driver’s under-
dash fuse/relay box.
4. Turn the ignition switch ON (II) and wait for 30
seconds. Then turn the ignition switch OFF.
5. Check the No. 2 (10A) fuse in the driver’s under-
dash fuse/relay box.
The system is OK at this time.
Go to step 6.
6. Replace the No. 2 (10A) fuse in the driver’s under-
dash fuse/relay box.
7. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
8. Disconnect the driver’s airbag connector (A), front
passenger’s airbag connector (B), and both seat
belt tensioner 2P connectors (C).
Does the SRS indicator go of f while the DT C
memor y is er ased?
Is the f use OK ?
Is the f use OK ?
03/07/29 10:41:25 61S0X050_230_0340