Honda 2004 Odyssey, Service Manual

Page: 181 / 2459

＊０４
＊０５
＊０６
FRONT:
REAR:
Specified Air Pressure:
390 kPa (4.0 kgf/cm , 57 psi)
2
6-14
Cylinder Head
VTEC Rocker Arm Test (cont’d)
07VAJ-P8A010A
070AJ-0030100
07AAJ-PNAA100
07VAJ-P8A010A
070AJ-0030100
07AAJ-PNAA100
A
B C
7. Remove the two end intake rocker shaft mounting
bolts, then install and connect the special tools as
shown.
8. Loosen the valve on the regulator, and apply the
specified air pressure.
NOTE: If the synchronizing pistons A and B do not
move after applying air pressure, move the primary
or secondary rocker arm up and down manually.
9. Make sure that the intake primary rocker arm (A)
and intake secondary rocker arm (B) are
mechanically connected by the piston and that the
mid rocker arm (C) does not move when pushed
manually. If any intake mid rocker arm moves
independently of the primary and secondary rocker
arms, replace the rocker arms as a set.
10. Remove the tools.
11. Tighten the rocker shaft bolts to 24 N·m (2.4 kgf·m,
17 lbf·ft)
12. Install the cylinder head covers (see page 6-34).
03/07/29 09:10:39 61S0X050_060_0014