Honda 2004 Odyssey, Service Manual

Page: 1201 / 2459

＊０１
＊０４
＊０２
Installation
18-34
Rear Suspension
Spring/Bump Stop Replacement (cont’d)
10 x 1.25 mm
39 N·m
(4.0 kgf·m, 29 lbf·ft)
D
C
E
B
A
C
12 x 1.25 mm
83 N·m
(8.5 kgf·m, 61 lbf·ft)
A
B
9.8 N·m
(1.0 kgf·m,
7.2 lbf·ft)
A
12 x 1.25 mm
74 N·m (7.5 kgf·m,
54 lbf·ft)
B
1. Install the bump stop (A).
2. Install the spring (C), and the upper spring seat (D).
Align the bottom of the spring and the lower spring
seat (E) with the lower arm B as shown.
3. Lower the rear suspension. Position the lower arm
B, and loosely install the flange bolt (A) and self-
locking nut (C).
4. Position a floor jack at the connecting point of the
lower arm B and the knuckle.
5. Slowly raise the jack until you can align the bolt
hole with the holes in the lower arm B and the
knuckle by raising the flange bolt.
6. Raise the rear suspension with a floor jack until the
vehicle just lifts off the safety stands.
7. Tighten the self-locking nut.
8. Tighten the flange bolt (A).
9. Install the wheel sensor.
10. Install the rear wheel.
11. Check the rear wheel alignment, and adjust it if
necessary (see page 18-5).
03/07/29 09:51:24 61S0X050_180_0034