Honda 2004 Odyssey, Service Manual

Page: 2269 / 2459

−
−
−
−
−
０５
０１
Ｓ０Ｘ４ＡＺＢＫ７９１０００Ｒ１１３ＸＦＡＡＴ００
YES
NO
Special Tools Required
YES
NO
’03-04 Models
DTC 11-3x (11-30 to 11-39, 11-3A to 11-3F):
DTC 11-6x (11-60 to 11-69, 11-6A to 11-6F):
23-204 23-204
SRS
DTC Troubleshooting (cont’d)
CABLE REEL 4P CONNECTOR
A
07XAZ-SZ30100
07SAZ-TB4011A
17. Check resistance between the No. 4 and No. 3
terminals of the cable reel 4P connector, and
between the No. 2 and No. 1 terminals. There
should be 2.0
3.0 .
Open or increased resistance in the SRS
main harness; replace the SRS main harness.
Replace the cable reel (see page 23-377).
• SRS inflator simulator 07SAZ-TB4011A
• SRS simulator lead F 07XAZ-SZ30100
• SRS short canceler 070AZ-SAA0100
1. Erase the DTC memory (see page 23-39).
2. Turn the ignition switch ON (II), and check that the
SRS indicator comes on for about 6 seconds and
then goes off.
Go to step 3.
Intermittent failure, system is OK at this time.
Go to Troubleshooting Intermittent Failures (see
page 23-39).
3. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
4. Disconnect the driver’s airbag 4P connector from
the cable reel (A).
5. Connect the special tool (2 connectors) to the
cable reel 4P connector.
Short to Another Wire or Decreased
Resistance in Driver’s Airbag First Inflator
Short to Another Wire or Decreased
Resistance in Driver’s Airbag Second Inflator
Wire side of female terminals
Is the r esistance as specif ied?
Does the SRS indicator stay on?
03/07/29 10:37:46 61S0X050_230_0204