Honda 2004 Odyssey, Service Manual

Page: 946 / 2459

−
−
−
−
−
−
−
０３
＊０２
０４
YES
NO
YES
NO
YES
NO
14-333
LG2 (BRN/YEL)
SH B (GRN/WHT)
LG1 (BRN/YEL)
PCM CONNECTORS
B (25P) D (16P)
SHIFT SOLENOID VALVE B CONNECTOR
B (25P) D (16P)
LG1 (BRN/YEL) LG2 (BRN/YEL)
VB SOL (BLK/YEL)
PCM CONNECTORS
8. Disconnect the 2P connector from shift solenoid
valve B.
9. Check for continuity between PCM connector
terminals D2 and B20 or B22 .
Repair short to ground in the wire between
PCM connector terminal D2 and shift solenoid
valve B.
Go to step 10.
10. Measure shift solenoid valve B resistance at the
solenoid valve connector.
Check for an open in the wire between PCM
connector terminal D2 and shift solenoid valve B,
and between shift solenoid valve B connector
terminal No. 1 and ground (G101).
Replace the shift solenoid valve B (see page
14-358).
11. Turn the ignition switch ON (II).
12. Measure the voltage between PCM connector
terminals D5 and B20 or B22.
Check for loose terminal fit in the PCM
connectors D2 and D5. If necessary, substitute a
known-good PCM and recheck.
Check for blown No. 6 (15A) fuse in the
driver’s under-dash fuse/relay box. If the fuse is OK,
repair open in the wire between PCM connector
terminal D5 and the driver’s under-dash fuse/relay
box.
Wire side of female terminals
Terminal side of male terminals
Wire side of female terminals
Is ther e continuity?
Is the r esistance 12 25 ?
Is ther e batter y voltage?
03/07/29 09:39:06 61S0X050_140_0336