Honda 2004 Odyssey, Service Manual

Page: 1138 / 2459

０５
＊０３
０７
０８
Reassembly
17-19
B
C
A
A
B
A
C
B
D
F
C
B
A
E
D
13. Attach a hose (A) to the end of the flow control
valve (B) as shown. Then submerge the flow
control valve in a container of power steering fluid
or solvent (C), and blow in the hose.
• If air bubbles leak through the valve at less than
98 kPa (1.0 kgf/cm , 14.2 psi), replace the pump
as an assembly. The flow control valve is not
available separately.
• If the flow control valve tests OK, set it aside for
reassembly later.
14. Inspect the ball bearing by rotating the outer race
slowly. If you feel any play (axial or radial) or
roughness remove the faulty ball bearing (A), and
install a new one (B).
15. Inspect each part shown with an asterisk in the
Exploded View; if any of them are worn or
damaged, replace the pump as an assembly.
16. Clean the disassembled parts with solvent, and dry
them with compressed air. Do not dip the rubber
parts in solvent.
17. Align the pin (A) of the subvalve (B) with the oil
passage (C) in the pump housing. Push the
subvalve into place, then install the snap ring (D).
18. Install the new pump seal (A) (with its grooved side
facing in) into the pump housing by hand, then
install the pump seal spacer (B).
19. Position the pump drive shaft (C) in the pump
housing (D), then drive it in using a 29 mm socket
(E).
20. Install the 40 mm snap ring (F) with its radiused
side facing out.
(cont’d)
2
03/07/29 09:49:01 61S0X050_170_0019