Honda 2004 Odyssey, Service Manual

Page: 464 / 2459

−
−
−
−
−
−
−
０２
＊０１
Ｓ０Ｘ４ＡＺ６Ｋ７７１０００９１２９８ＦＡＡＴ００
YES
NO
YES
NO
YES
NO
DTC P1298 ’99-00, ’02-04 Models:
11-155 11-155
PCM CONNECTOR E (31P)
ELD (GRN/RED)
ELD 3P CONNECTOR
IG1 (BLK/YEL)
8. Turn the ignition switch OFF.
9. Disconnect PCM connector E (31P).
10. Check for continuity between body ground and
PCM connector terminal E19.
Repair short in the wire between the PCM
(E19) and the ELD.
Substitute a known-good PCM and recheck
(see page 11-5). If the symptom/indication goes
away, replace the original PCM.
1. Reset the PCM (see page 11-4).
2. Start the engine.
3. Turn on the headlights.
Go to step 4.
Intermittent failure, system is OK at this time.
Check for poor connections or loose terminals at
the ELD and the PCM.
4. Turn the ignition switch and headlights OFF.
5. Disconnect the ELD 3P connector.
6. Turn the ignition switch ON (II).
7. Measure voltage between body ground and ELD 3P
connector terminal No. 1.
Go to step 8.
Check the No. 6 ECU (PCM) CRUISE
CONTROL (15A) fuse in the driver’s under-dash
fuse/relay box. If the fuse is OK, repair open in the
wire between the No. 6 ECU (PCM) CRUISE
CONTROL (15A) fuse and the ELD.
8. Turn the ignition switch OFF.
(cont’d)
ELD
Circuit High Voltage
Wire side of female terminals
Wire side of female terminals
Is ther e continuity?
Is DT C P1298 indicated?
Is ther e batter y voltage?
03/07/29 09:22:46 61S0X050_110_0155