Honda 2004 Odyssey, Service Manual

Page: 1260 / 2459

＋ −
＋ −
−
−
−
＋ −
−
− ＋ −
＋ −
−
−
−
＋ −
＋ −
−
＋ −
−
＋ −
＋ −
＋ −
＋ −
＋ −
＋ −
＋ −
＋ −
＊０１
＊０１
Ｓ０Ｘ４Ａ０７Ｋ７０１０００８１１２０ＦＡＡＴ００
＋
＋
＋
＋
−
−
−
−
＋
＋
＋
＋
−
−
−
−
DTC Appropriate Terminal
( ) Side ( ) Side
YES
NO
YES
NO
DTC Appropriate Wheel Sensor
YES
NO
DTC Appropriate Terminal
( ) Side ( ) Side
YES
NO
DTC 12, 14, 16, 18:
19-59 19-59
ABS CONTROL UNIT CONNECTOR A (22P)
FLW ( ) (GRN/BLU)
FRW ( ) (GRN/BLK)
RLW ( ) (LT BLU)
RRW ( ) (GRN/YEL)
FLW ( ) (BRN)
FRW ( ) (GRN)
RRW ( ) (BLU/YEL)
RLW ( ) (GRY)
ABS CONTROL UNIT CONNECTOR A (22P)
FLW ( ) (GRN/BLU)
FRW ( ) (GRN/BLK)
RLW ( ) (LT BLU)
RRW ( ) (GRN/YEL)
FLW ( ) (BRN)
FRW ( ) (GRN)
RRW ( ) (BLU/YEL)
RLW ( ) (GRY)
6. Check the resistance between the appropriate
wheel sensor ( ) and ( ) circuit terminals (see
table).
11 (Right-front)
13 (Left-front)
15 (Right-rear)
17 (Left-rear)
Check for loose ABS control unit connectors.
If necessary, substitute a known-good ABS control
unit, and recheck.
Go to step 7.
7. Disconnect the harness 2P connector from the
appropriate wheel sensor, and check the resistance
between the (
) and ( ) terminals of the wheel
sensor.
Repair open in the ( ) or ( ) circuit wire, or
short beween the ( ) circuit wire and the ( )
circuit wire between the ABS control unit and the
wheel sensor.
Replace the wheel sensor.
NOTE: If the ABS indicator comes on because of
electrical noise, the indicator goes off when you test-
drive the vehicle at 19 mph (30 km/h).
1. Visually check for appropriate wheel sensor and
pulser installation (see table).
12 Right-front
14 Left-front
16 Right-rear
18 Left-rear
Go to step 2.
Reinstall or replace the appropriate wheel
sensor or pulser.
2. Disconnect the ABS control unit connector A (22P).
3. Measure the resistance between the appropriate
wheel sensor ( ) and ( ) circuit terminals (see
table).
12 (Right-front)
14 (Left-front)
16 (Right-rear)
18 (Left-rear)
Repair a short in the wires between the
appropriate wheel sensor ( ) and ( ) circuits.
Go to step 4.
(cont’d)
No. 9: FRW ( ) No. 8: FRW ( )
No. 7: FLW ( ) No. 6: FLW ( )
No. 19: RRW ( ) No. 20: RRW ( )
No. 17: RLW ( ) No. 18: RLW ( )
No. 9: FRW ( ) No. 8: FRW ( )
No. 7: FLW ( ) No. 6: FLW ( )
No. 19: RRW ( ) No. 20: RRW ( )
No. 17: RLW ( ) No. 18: RLW ( )
Wheel Sensor (Electrical
Noise/Intermittent Interruption)
Wire side of female terminals
Wire side of female terminals
Is the r esistance between 450 2,000 ?
Is the r esistance between 450 2,000 ?
Ar e they installed cor r ectly?
Is ther e less than 450 ?
03/07/29 09:55:47 61S0X050_190_0059