Honda 2004 Odyssey, Service Manual

Page: 2249 / 2459

−
−
−
−
０１
＊０２
Ｓ０Ｘ４ＡＣ５Ｋ７９１０００８１１４３ＦＡＡＴ００
’02 Model
DTC 14-3:
Special Tools Required
YES
NO
YES
NO
23-184
SRS
DTC Troubleshooting (cont’d)
A
A
07YAZ-S3AA100
07SAZ-TB4011A
B
A
No Signal from the Front
Passenger’s Side Impact Sensor
• SRS inflator simulator 07SAZ-TB4011A
• SRS simulator lead H 07YAZ-S3AA100
1. Erase the DTC memory (see page 23-38).
2. Turn the ignition switch ON (II), and check that the
SRS indicator comes on for about 6 seconds and
then goes off.
Go to step 3.
Intermittent failure, system is OK at this time.
Go to Troubleshooting Intermittent Failures (see
page 23-39).
3. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
4. Check the connection between the right side wire
harness 2P connector and the front passenger’s
side impact sensor.
Go to step 5.
Poor contact between the right side wire
harness 2P connector and the front passenger’s
side impact sensor; replace the front passenger’s
side impact sensor (see page 23-385).
5. Disconnect the driver’s side airbag and front
passenger’s side airbag 2P connectors (A).
6. Disconnect the right side wire harness 2P
connector (A) from the front passenger’s side
impact sensor (B).
7. Connect the special tool (jumper connector) to the
right side wire harness 2P connector.
Does the SRS indicator stay on?
Is the connection OK ?
03/07/29 10:36:27 61S0X050_230_0184