Honda 2004 Odyssey, Service Manual

Page: 227 / 2459

０１
＊０１
Ｓ０Ｘ４Ａ００Ａ２０３２６９１６０８５ＫＢＡＴ００
6-60 6-60
Cylinder Head
Cylinder Head Installation (cont’d) CMP (TDC) Sensor Replacement
12 x 1.25 mm
90 N·m (9.2 kgf·m, 67 lbf·ft)
8 x 1.25 mm
22 N·m (2.2 kgf·m, 16 lbf·ft)
26. Clean the battery posts and cable terminals with
sandpaper, then assemble them and apply grease
to prevent corrosion.
27. After installation, check that all tubes, hoses and
connectors are installed correctly.
28. Inspect for fuel leaks. Turn the ignition switch ON
(II) (do not operate the starter) so that the fuel pump
runs for about 2 seconds and pressurizes the fuel
line. Repeat this operation two or three times, then
check for fuel leakage at any point in the fuel line.
29. Refill the radiator with engine coolant, and bleed
air from the cooling system with the heater valve
open (see step 8 on page 10-13).
30. Inspect the idle speed (see page 11-201).
31. Inspect the ignition timing (see page 4-16).
1. Set the No.1 piston at top dead center (TDC) (see
page 6-20).
2. Remove the upper covers.
3. To hold the timing belt adjuster in its current
position, thread in the battery clamp bolt hand-tight
(see step 13 on page 6-22).
4. Remove the idler pulley bolt and idler pulley, then
remove the timing belt from the front camshaft
pulley (see step 15 on page 6-22).
5. Remove the front camshaft pulley.
6. Disconnect the camshaft position (CMP) (top dead
center (TDC) ) sensor connector, then remove the
back cover.
Apply engine oil to
the bolt threads.
03/07/29 09:12:00 61S0X050_060_0060