Honda 2004 Odyssey, Service Manual

Page: 1193 / 2459

０１
＊０２
０３
＊０１
Ｓ０Ｘ４Ａ００Ｂ４４１０００６２２０１ＫＤＡＴ００
−
−
−
Special Tools Required
18-26
Rear Suspension
Upper Arm Removal/Installation
B
A
07MAC-SL00200
12 x 1.25 mm
49
59 N·m
(5.0 6.0 kgf·m,
36 43 lbf·ft)
A
12 x 1.25 mm
64 N·m
(6.5 kgf·m, 47 lbf·ft)
B
B
A
Ball joint remover, 28 mm 07MAC-SL00200
1. Raise the rear of the vehicle, and support it with
safety stands in the proper locations
(see page 1-15). Remove the rear wheel.
2. Position a floor jack at the connecting point of the
lower arm B and the knuckle (A).
3. Remove the lock pin from the upper ball joint castle
nut, and remove the nut.
4. Remove the upper ball joint from the knuckle using
the special tool (see page 18-10).
5. Remove the upper arm bolt (A). Remove the upper
arm (B) from the vehicle.
6. Install the upper arm.
7. Install the upper arm bolt and castle nut. Tighten
finger tight.
8. Position a floor jack at the connecting point of the
lower arm B and the knuckle (A).
9. Raise the rear suspension with the floor jack until
the vehicle just lifts off the safety stands.
10. Tighten the upper arm bolt to the specific torque
value, and note these items:
• Be careful not to damage the ball joint boot when
connecting the upper arm to the knuckle.
• Tighten the castle nut to the lower torque
specifications, then tighten it only far enough to
align the slot with the hole in the stud. Do not
align the castle nut by loosening it.
• Use a new lock pin in the castle nut.
• Before installing the wheel, clean the mating
surfaces on the brake drum or the drum in brake
disc and the inside of the wheel.
• Check the rear wheel alignment, and adjust it if
necessary (see page 18-5).
03/07/29 09:51:19 61S0X050_180_0026