Honda 2004 Odyssey, Service Manual

Page: 2312 / 2459

−
−
−
−
０１
０１
０２
Ｓ０Ｘ４ＡＳＩＫ７９１０００Ｒ３１３ＸＦＡＡＴ００
’03-04 Models
DTC 31-3x (31-30 to 31-39, 31-3A to 31-3F):
Special Tools Required
YES
NO
YES
NO
23-247
07SAZ-TB4011A
07XAZ-S1A0200
A
A
B
Short to Another Wire or Decreased
Resistance in Driver’s Side Airbag Inflator
• SRS inflator simulator 07SAZ-TB4011A
• SRS simulator lead E 07XAZ-S1A0200
• SRS short canceler 070AZ-SAA0100
1. Erase the DTC memory (see page 23-39).
2. Turn the ignition switch ON (II), and check that the
SRS indicator comes on for about 6 seconds and
then goes off.
Go to step 3.
Intermittent failure, system is OK at this time.
Go to Troubleshooting Intermittent Failures (see
page 23-39).
3. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
4. Disconnect the left side wire harness 2P connector
(A) from the driver’s side airbag.
5. Connect the special tool (2 connector) to the left
side wire harness 2P connector.
6. Reconnect the battery negative cable.
7. Erase the DTC memory.
8. Read the DTC (see page 23-38).
Go to step 9.
Short to another wire in the driver’s side
airbag inflator; replace the driver’s side airbag.
9. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
10. Disconnect both seat belt tensioner 2P connectors
from the side wire harness (A).
11. Disconnect SRS unit connector B (28P) from the
SRS unit.
(cont’d)
Does the SRS indicator stay on?
Is DT C 31-3x indicated?
03/07/29 10:38:13 61S0X050_230_0247