Honda 2004 Odyssey, Service Manual

Page: 478 / 2459

−
−
−
−
−
−
−
−
０２
Ｓ０Ｘ４ＡＺ１Ａ２０３２６９３９９０２ＦＡＡＴ００
YES
NO
YES
NO
YES
NO
YES
NO
’01 Model
11-169 11-169
SCS (BRN)
PCM CONNECTOR A (32P)
23. Turn the ignition switch OFF.
24. Disconnect PCM connector A (32P).
25. Check for continuity between PCM connector
terminal A10 and body ground.
Repair short in the wire between the data link
connector (DLC) and the ECM/PCM (A10).
Substitute a known-good ECM/PCM and
recheck (see page 11-5). If the symptom/indication
goes away, replace the original ECM/PCM.
26. Turn the ignition switch OFF.
27. Disconnect PCM connector A (32P).
28. Turn the ignition switch ON (II).
Repair short in the wire between the gauge
assembly and the PCM (A18).
Substitute a known-good PCM and recheck
(see page 11-5). If the symptom/indication goes
away, replace the original PCM.
1. Connect the HDS (see page 11-4).
2. Turn the ignition switch ON (II), and read the HDS.
Go to step 3.
Go to step 4.
3. Check the DTCs with the HDS.
Go to the DTC Troubleshooting Index.
Go to step 4.
4. Turn the ignition switch OFF.
(cont’d)
Wire side of female terminals
Is ther e continuity?
Does the MIL stay on?
Does the HDS communicate with the PCM?
Ar e any DT Cs indicated?
03/07/29 09:22:55 61S0X050_110_0169