Honda 2004 Odyssey, Service Manual

Page: 2149 / 2459

−
−
−
−
−
−
０１
＊０１
Ｓ０Ｘ４ＡＺ４Ｋ７９１０００８１０３３ＦＡＡＴ００
’99-01 Models
DTC 3-3:
YES
NO
YES
NO
YES
NO
23-84
SRS
DTC Troubleshooting (cont’d)
07TAZ-SZ5011A
07SAZ-TB4011A
A
A
07TAZ-SZ5011A
07SAZ-TB4011A
C551
Short to Another Wire or Decreased
Resistance in Driver’s Seat Belt Tensioner
1. Erase the DTC memory (see page 23-38).
2. Turn the ignition switch ON (II), and check that the
SRS indicator comes on for about 6 seconds and
then goes off.
Go to step 3.
Intermittent failure, system is OK at this time.
Go to Troubleshooting Intermittent Failures (see
page 23-39).
3. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
4. Disconnect the driver’s seat belt tensioner 2P
connector from the left side wire harness 2P
connector (A).
5. Connect the special tool (2 connector) to the left
side wire harness 2P connector.
6. Reconnect the battery negative cable.
7. Erase the DTC memory.
8. Read the DTC (see page 23-35).
Go to step 9.
Short in the driver’s seat belt tensioner;
replace the driver’s seat belt (see page 23-4).
9. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
10.
11. connector) to the SRS
main harness 2P connector.
12. Reconnect the battery negative cable.
13. Erase the DTC memory.
14. Read the DTC.
Go to step 15.
Short in left side wire harness; replace the left
side wire harness.
15. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
Does the SRS indicator stay on?
Is DT C 3-3 indicated?
Is DT C 3-3 indicated?
03/07/29 10:33:06 61S0X050_230_0084
Connect the special tool (2
Disconnect the SRS main harness 2P connector
C551 from the left side wire harness 2P connector (A).