Honda 2004 Odyssey, Service Manual

Page: 1319 / 2459

−
−
−
−
−
−
＊０７
＊０８
Ｓ０Ｘ４Ａ０６Ｋ７０２０００８１４１０ＦＡＡＴ００
DTC Appropriate Terminal
YES
NO
YES
NO
DTC Appropriate Wheel Sensor
YES
NO
ABS DTC 41, 42, 43, 44:
19-118 19-118
ABS/TCS Components
DTC Troubleshooting (cont’d)
ABS/TCS CONTROL UNIT CONNECTOR C (12P)
ABS/TCS CONTROL UNIT CONNECTOR A (26P)
(YEL/WHT)
FL-OUT
(YEL/GRN) (YEL/BLK)
(RED/BLU) (RED/GRN) (RED/BLK) (RED/WHT)
(YEL/BLU)
RR-OUT RL-OUT
FR-OUT
RR-IN FL-IN RL-IN
FR-IN
NCR
(GRY) NOR
(LT BLU)
NOL
(RED/GRN)
NCL
(YEL/GRN)
16. Connect the modulator unit connector.
17. Check for continuity between appropriate ABS/TCS
control unit connector C (12P) terminal and all other
ABS and TCS solenoid circuit terminals (see table).
31: FR-IN No. 11
32: FR-OUT No. 6
33: FL-IN No. 9
34: FL-OUT No. 4
35: RR-IN No. 8
36: RR-OUT No. 3
37: RL-IN No. 10
38: RL-OUT No. 5
Replace the modulator unit.
Check for loose ABS/TCS control unit
connectors. If necessary, substitute a known-good
ABS/TCS control unit, and recheck.
1. Test-drive the vehicle, and apply the brake several
times to raise the brake temperature.
2. Raise the vehicle on a hoist, and check for
excessive brake drag.
Repair the cause of brake drag.
Go to step 3.
3. Check the installation of the appropriate wheel
sensor (see table).
41 Right-front
42 Left-front
43 Right-rear
44 Left-rear
The probable cause was the vehicle spun
during cornering. If the problem recurs, check the
modulator unit using the HDS.
Reinstall the wheel sensor correctly.
Wheel Lock
Wire side of female terminals
Wire side of female terminals
Is ther e less than 3 ?
Is ther e excessive br ake dr ag?
Is it installed cor r ectly?
03/07/29 09:57:38 61S0X050_190_0118