Honda 2004 Odyssey, Service Manual

Page: 2444 / 2459

＊０１
０７
０８
０９
Installation (’99-01 models)
23-379
A
B
A
B
D
C
B
A
D
D C
1. Before installing the steering wheel, the front
wheels should be aligned straight ahead.
2. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait at least 3 minutes.
3. Set the cancel sleeve (A) so that the projections (B)
are aligned vertically.
4. Carefully install the cable reel (A) on the steering
column shaft. Then connect the 4P connector (B) to
the cable reel, and connect the 2P connector (C) to
the SRS main harness 2P connector (D).
5. Install the steering column covers.
6. If necessary, center the cable reel. (New
replacement cable reels come centered.) Do this by
first rotating the cable reel clockwise until it stops.
Then rotate it counterclockwise about 2 1/2 turns
until the arrow mark on the cable reel label points
straight up.
7. Position the two tabs (A) of the turn signal cancel
sleeve (B) as shown, and install the steering wheel
on to the steering column shaft, making sure the
steering wheel hub (C) engages the pins (D) of the
cable reel and tabs of the canceling sleeve. Do not
tap on the steering wheel or steering column shaft
when installing the steering wheel.
(cont’d)
03/07/29 10:42:52 61S0X050_230_0379