Honda 2004 Odyssey, Service Manual

Page: 1892 / 2459

＋ −
＋
−
−
＋
−
−
０１
０２
Ｓ０Ｘ４Ａ００Ｊ５４４６０６４７１０２ＦＥＡＴ００
Pulser Test
22-213 22-213
Passenger’s Window Motor Test
Terminal
Direction
UP
1 2
DOWN
5. Reconnect the 4P connector to the window motor.
6. Check for voltage between the terminals.
• There should be battery voltage between the
B4 ( ) and B2 ( ) terminals when the ignition
switch ON (II).
• Connect an analog voltmeter between the B3 ( )
and B2 ( ) terminals, and run the window motor
at down or up. The voltmeter needle should
move back and forth alternately (a digital
voltmeter should show the average voltage
between 0
5 V).
• Connect an analog voltmeter between the B1 ( )
and B2 ( ) terminals, and run the window motor
at down or up. The voltmeter needle should
move back and forth alternately. (a digital
voltmeter should show the average voltage
between 0
5 V).
7. If the test is not as specified, replace the driver’s
window motor.
1. Remove the passenger’s door panel (see page 20-
7).
2. Disconnect the 2P connector from the window
motor.
3. Check window motor operation by connecting
power and ground according to the table. When the
motor stops running, disconnect one lead
immediately.
4. If the motor does not run or fails to run smoothly,
replace it.
Terminal side of male terminals
03/07/29 10:24:12 61S0X050_220_0215