Freescale Semiconductor MPC5565, Reference Manual

Page: 978 / 1153

Voltage Regulator Controller (VRC) and POR Module
MPC5565 Microcontroller Reference Manual, Rev. 1.0
Freescale Semiconductor 22-5
22.5 Initialization and Application Information
22.5.1 Voltage Regulator Example
Figure 22-3 shows how to connect the VRC to the device.
Figure 22-3. Voltage Regulator Controller Hookup
NOTE
Do not use Figure 22-3 as a reference for board design. Refer to Application
Note AN3254 for resistor requirements.
22.5.2 Compatible Power Transistors
The following NPN transistors are compatible with the on-chip VRC:
• ON Semiconductor
TM
NJD2873
• Phillips Semiconductor
TM
BCP68
Refer to the MPC5565 Microcontroller Data Sheet for information on the operating characteristics.
22.5.3 Power Sequencing Requirements
This section describes the following power sequencing requirements for the device:
• If an external 1.5 V power supply is used and V
RC33
is tied to ground, power sequencing is required
between the 1.5 V power supply, and V
DDSYN
and the RESET power supplies. To avoid this power
sequencing requirement, power up V
RC33
within the specified operating range, even if not using
the on-chip voltage regulator controller.
Refer to
Section 22.5.3.1, “Power-Up Sequence If V
RC33
Grounded ” and Section 22.5.3.2,
“Power-Down Sequence If V
RC33
Grounded .”
• The V
DD33
voltage must be high enough before POR negates to ensure the values on certain pins
are treated as 1s when POR negates.
Refer to
Section 22.5.3.3, “Input Value of Pins During POR Dependent on V
DD33
.”
MCU
V
RC33
V
RCCTL
V
DD
Note AN3254 for
resistor requirements.
Refer to Application