Freescale Semiconductor MPC5565, Reference Manual

Page: 107 / 1153

Signal Description
MPC5565 Microcontroller Reference Manual, Rev. 1.0
2-50 Freescale Semiconductor
2.6 Document Revision History
Table 2-8. Changes Between MPC5565RM Revisions 0.1 and 1
Table 2-2 MPC5565 Signal Descriptions: Added the phrase V
DDE3
can be connected internally to V
DDE2
to footnote 34.
First sentence in the EVTI signal description changed to: EVTI is an input that is read during a debug port reset to enable or
disable the Nexus Auxiliary port (for trace).
Table 2-3 and Table 2-4 ( MPC5565 Power / Ground Segmentation tables): Changed footnote 1 to start with “These are nominal
voltages. Changed the V
DDE
supplies to
±
10%; the V
DDEH
supplies are +5% to –10%.”
Additional changes are:
• For REFBYPC, V
RL
, and V
RH
, placed a “–” in the Voltage cell of the signal table. These are independent of supply and clamp
to the global VSS. Added footnote 23.
• Table 2-2 MPC5565 Signal Descriptions: Added TXDA and RXDA to CNTXA_GPIO[83] and CNRXA_GPIO[84] signals
respectively.
• Table 2-3 MPC5565 Power / Ground Segmentation for the 324 Package: Added TXDA and RXDA to CNTXA_GPIO[83] and
CNRXA_GPIO[84] signals respectively.
• Table 2-4 MPC5565 Power / Ground Segmentation for the 496 Assembly: Added TXDA and RXDA to CNTXA_GPIO[83]
and CNRXA_GPIO[84] signals respectively.
Added information on the differences between the device design and the 324 package limitations.
In Section 2.1, “Block Diagram,” added Table 2-1 MPC5565 324 Package Limitations. Added sentence and note after Table 2-1
that reads:
Refer to the last two columns in Table 2-2 for a comparison of available signals on the 324 package compared to the VertiCal
assembly.
NOTE
The Vertical assembly has ball connections for all the available signals on the device.
Added two footnotes in Figure 2-1, MPC5565 Signal Diagram :
1
The 324 package does not support all muxed signals designed for this device. Refer to Table 2-1 for a list of the signals that are not
supported on the 324 package.
2
The calibration signals only function when using the VertiCal assembly.
Put footnote 1 in the diagram next to all signals from Table 2-1 MPC5565 324 Package Limitations except for the calibration
signals. Put footnote 2 in the diagram next to all the calibration signals.
Table 2-2 MPC5565 Signal Descriptions: Added footnotes 13 and 16 for the 324 package limitations.
13
These signals are not available on the 324 package.
16
These signals are available on the Vertical assembly only.