Panasonic ZEQUO 6400, Operating Instructions Manual

Page: 22 / 1058

4. Using Command Line Interface
23
4. Using Command Line Interface
The Command Line Interface (CLI) is an operation screen to configure and
manage this Switching Hub.
You can use the CLI by connecting a VT-100 compatible terminal to the
serial port of this Switching Hub or through a remote connection such as
telnet.
This chapter describes the following CLI procedures.

Overview of connecting to the serial port
 How to configure the IP address of this Switching Hub

Overview of how to use commands
- "?" command, which displays the command help
- Operations when parameters are omitted
- Using command autocomplete function and input history
- Operations when making a typo
 Syntax rules

Available input editing keys and page operation keys
4.1. Accessing the Switch via the Serial Port
The Switch's serial port's default settings are as follows:

9600 baud
 no parity

8 data bits
 1 stop bit
A computer running a terminal emulation program capable of emulating a VT-100 terminal
and a serial port configured as above is then connected to the Switch's serial port via an RJ-
45 to RS-232 DB-9 convertor cable.
With the serial port properly connected to a management computer, the following screen
should be visible.
Zxxx0 Gigabit Ethernet Switch
Command Line Interface
Firmware: Build 1.0.x.xx
UserName: