Panasonic ZEQUO 6400, Operating Instructions Manual

Page: 986 / 1058

87. VLAN Commands
987

Example
To display 802.1q port settings for ports 1 to 3:
87.9. config gvrp

Description
This command is used to set the GVRP timer's value.
 Format
config gvrp [timer [join | leave | leaveall] <value 100-100000> | nni_bpdu_addr [dot1d |
dot1ad]]

Parameters

Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Zxxx0:admin#show port_vlan 1-3
Command: show port_vlan 1-3
Port PVID GVRP Ingress Checking Acceptable Frame Type
------- ---- -------- ---------------- ----------------------------
1 1 Disabled Enabled All Frames
2 1 Disabled Enabled All Frames
3 1 Disabled Enabled All Frames
Total Entries : 3
Zxxx0:admin#
timer Specify GVRP timer.
join
Specify the Join time will be set. The default value is 200 milliseconds.
leave Specify the Leave time will be set. The default value is 600 milliseconds.
leaveall
Specify the LeaveAll time. The default value is 10000 milliseconds.
<value 100-100000>
Specify the time value. The value range is 100 to 100000 milliseconds. In addition, the
Leave time should greater than 2 Join times and the LeaveAll time should greater than
Leave time.
nni_bpdu_addr
Determine the BPDU protocol address for GVRP in service provide site. It can use 802.1d
GVRP address, or 802.1ad service provider GVRP address.
dot1dSpecify a 802.1d GVRP address.
dot1ad
Specify a 802.1ad service provider GVRP address.