80. System Severity Commands
912
80.System Severity Commands
The commands are used to configure the significance level of events,
such as trapping or logging, in trap and log management using SNMP
(Simple Network Management Protocol).
80.1. config system_severity
Description
This command is used to configure severity level control for the system.
Format
config system_severity [trap | log | all] [emergency | alert | critical | error | warning |
notice | information | debug | <level 0-7>]
Parameters
Restrictions
Only Administrator and Operator-level users can issue this command.
config system_severity [trap | log | all] [emergency | alert | critical | error | warning | notice |
information | debug | <level 0-7>]
show system_severity
trap
Configure severity level control for a trap.
log
Configure severity level control for a log.
all
Configure severity level control for a trap and a log.
emergency
Specify to configure the severity level for emergency messages.
alert
Specify to configure the severity level for alert messages.
critical
Specify to configure the severity level for critical messages.
error
Specify to configure the severity level for error messages.
warning Specify to configure the severity level for warning messages.
notice
Specify to configure the severity level for notice messages.
informational
Specify to configure the severity level for informational messages.
debug
Specify to configure the severity level for debug messages.
<level 0-7>
Specify to configure a severity level between 0 and 7.
Summary of Contents for ZEQUO 6400
