Panasonic ZEQUO 6400, Operating Instructions Manual

Page: 400 / 1058

34. Internet Group Management Protocol (IGMP) Commands
401

Example
To enable the checking of subscriber source IP addresses when an IGMP report or
leave message is received on the interface called 'System':
34.5. show igmp
check_subscriber_source_network

Description
This command is used to display the status of the IGMP report/leave message source
IP check.

Format
show igmp check_subscriber_source_network {ipif <ipif_name 12>}

Parameters

Restrictions
None.

Example
To show the status of the check subscriber for the received IGMP report/leave
messages on interface "n20":
Zxxx0:admin# config igmp check_subscriber_source_network ipif System enable
Command: config igmp check_subscriber_source_network ipif System enable
Success.
Zxxx0:admin#
ipif (Optional) Specifies the IP interface name used for this configuration.
<ipif_name 12>
Enter the IP interface name used for this configuration here. This name can be up
to 12 characters long.
If no parameter is specified, the system will display all interfaces.
Zxxx0:admin# show igmp check_subscriber_source_network ipif n20
Command: show igmp check_subscriber_source_network ipif n20
Interface IP Address/Netmask Check Subscriber Source Network
------------ ------------------ -------------------------------
n20 20.1.1.1/8 Disabled
Total Entries: 1
Zxxx0:admin#