Panasonic ZEQUO 6400, Operating Instructions Manual

Page: 569 / 1058

52. MLD Proxy Commands
570
52.4. config mld_proxy upstream_if
 Description
This command is used to configure the setting for the MLD proxy's upstream interface. The
MLD proxy plays the host role on the upstream interface. It will send MLD report packets to
the router port. The source IP address determines the source IP address to be encoded in
the MLD protocol packet. If the router port is empty, the upstream will send the MLD
protocol packet to all member ports on the upstream interface.

Format
config mld_proxy upstream_if {vlan [<vlan_name 32> | vlanid <vlanid 1-4094>] |
router_ports [add | delete] <portlist> | source_ip <ipv6addr> | unsolicited_report_interval
<sec 0-25>}(1)

Parameters

Restrictions
Only Administrator, Operator and Power-User level users can issue this command.

Example
To configure the router port of MLD proxy's upstream interface:
vlan Specify the VLAN for the upstream interface.
<vlan_name 32>
Specify a VLAN name between 1 and 32 characters.
vlanidSpecify the VLAN ID for the upstream interface.
<vlanid 1-4094>
Specify the VLAN ID between 1 and 4094.
router_ports
Specify a list of ports that are connected to multicast-enabled routers.
add
Specify to add the router ports.
deleteSpecify to delete the router ports.
<portlist>
Specify a range of ports to be configured.
source_ip
Specify the source IPv6 address of the upstream protocol packet. If it is not specified, zero
IP address will be used as the protocol source IP address.
<ipv6addr>
Specify the IPv6 address.
unsolicited_report_interval
Specify the time between repetitions of the host's initial report of membership in a group.
The default is 10 seconds. If set to 0, only one report packet is sent.
<sec 0-25>
Specify the time between 0 and 25 seconds.