Panasonic ZEQUO 6400, Operating Instructions Manual

Page: 795 / 1058

69. QoS Commands
796

Restrictions
Only Administrator, Operator and Power-User level users can issue this command.

Example
To configure the maximum rate to be 100 on queue 1 for ports 1 to 10:
69.4. show per_queue bandwidth_control

Description
This command is used to display the bandwidth control setting of per egress queue
for each port.

Format
show per_queue bandwidth_control {<portlist>}

Parameters
min_rateSpecify that one of the parameters below will be applied to the minimum rate that the
class specified above will be allowed to transmit packets at.
no_limit
Indicates there is no limit on egress queue of specified port bandwidth.
<value 64-10240000>
Specify an integer value from 64 to 10240000 to set a minimum limit in Kbits/sec.
The specified bandwidth limit may be equaled but not exceeded. The exact logical
limit or token value is hardware determined. Note: 1 Kbit = 1000 bits, 1 Gigabit =
1000*1000 Kbits. Actual rate = (inputted rate/ 64) * 64.
max_rateSpecify one of the parameters below will be applied to the maximum rate that the class
specified above will be allowed to transmit packets at.
no_limit
Indicates there is no limit on egress queue of specified port bandwidth.
<value 64-10240000>
Specify an integer value from 64 to 10240000 to set a maximum limit in Kbits/sec.
The specified bandwidth limit may be equaled but not exceeded. The exact logical
limit or token value is hardware determined. Note: 1 Kbit = 1000 bits, 1 Gigabit =
1000*1000 Kbits. Actual rate = (inputted rate/ 64) * 64.
Zxxx0:admin#config per_queue bandwidth_control ports 1-10 1 max_rate 100
Command: config per_queue bandwidth_control ports 1-10 1 max_rate 100
Granularity: TX: 64. Actual Rate: MAX: 64.
Success.
Zxxx0:admin#
<portlist>(Optional) Specify a range of ports to be displayed.