Panasonic ZEQUO 6400, Operating Instructions Manual

Page: 493 / 1058

45. Link Aggregation Commands
494

Example
To configure a link aggregation group, group-id 1, master port 7, member ports 5-7:
45.4. config link_aggregation algorithm

Description
This command is used to configure the part of the packet examined by the Switching
Hub when selecting the egress port for transmitting load-sharing data.
If the load sharing algorithm is based on IP information and the packet is a non-IP
packet, it will be based on the source MAC.
If the load sharing algorithm is based on L4 information and the packet is not a TCP/
UDP packet:
1)If the packet is a non-IP packet, it will be based on the source MAC.
2)If the packet is an IP packet, it will use the default value of "0" for the TCP/UDP
port. It means that if it is not a TCP/UDP IP packet, it will deal with it the same as
way as the TCP/UDP packets, but just the TCP/UDP value is 0.
 Format
config link_aggregation algorithm [mac_source | mac_destination | mac_source_dest
| ip_source | ip_destination | ip_source_dest | l4_src_port | l4_dest_port |
l4_src_dest_port]

Parameters
Zxxx0:admin#config link_aggregation group_id 1 master_port 7 ports 5-7
Command: config link_aggregation group_id 1 master_port 7 ports 5-7
Success.
Zxxx0:admin#
mac_source
Indicates that the Switching Hub should examine the MAC source address.
mac_destination
Indicates that the Switching Hub should examine the MAC destination address.
mac_source_dest
Indicates that the Switching Hub should examine the MAC source and destination
address.
ip_source
Indicate that the Switching Hub should examine the IP source address.
ip_destination
Indicate that the Switching Hub should examine the IP destination address.
ip_source_dest
Indicate that the Switching Hub should examine the IP source and destination address.