Panasonic ZEQUO 6400, Operating Instructions Manual

Page: 396 / 1058

34. Internet Group Management Protocol (IGMP) Commands
397
34.1. config igmp
 Description
This command is used to configure IGMP on the Switch.

Format
config igmp [ipif <ipif_name 12> | all] {version <value 1-3> | query_interval <sec 1-
31744> | max_response_time <sec 1-25> | robustness_variable <value 1-7> |
last_member_query_interval <value 1-25> | state [enable | disable]}

Parameters
ipif Specifies the IP interface name used for this configuration.
<ipif_name 12>
Enter the IP interface name used for this configuration here. This name can be up
to 12 characters long.
all Specifies that all the IP interfaces will be used.
version (Optional) Specifies the IGMP version used.
<value 1-3>
Enter the IGMP version number used here. This value must be between 1 and 3.
The default value is 3.
query_interval
(Optional) Specifies the time in seconds between general query transmissions.
<sec 1-31744>
Enter the query interval time here. This value must be between 1 and 31744
seconds. The default value is 125.
max_response_time
(Optional) Specifies the maximum time in seconds to wait for reports from members.
<sec 1-25>
Enter the maximum response time here. This value must be between 1 and 25
seconds. The default value is 10.
robustness_variable
(Optional) Specifies the permitted packet loss that guarantees IGMP.
<value 1-7>
Enter the robustness variable here. This value must be between 1 and 7. The
default value is 2.
last_member_query_interval
(Optional) Specifies the maximum Response Time inserted into the Group-Specific
Queries that are sent in response to Leave Group messages, which is also the amount of
time between Group-Specific Query messages.
<value 1-25>
Enter the last member query interval value here. This value must be between 1 and
25. The default value is 1.
state (Optional) Specifies the IGMP state on a router interface.
enable
Specifies that the IGMP state will be enabled.
disable
Specifies that the IGMP state will be disabled.