Panasonic ZEQUO 6400, Operating Instructions Manual

Page: 887 / 1058

76. Stacking Commands
888
76.2. config stacking force_master_role state
 Description
This command is used to configure stacking force master role state. If state is enabled,
when device is in election state, it still uses old priority setting and MAC to compare
device priority. After stacking is stable, master's priority will become zero. If stacking
topology change again, Master will use priority zero and MAC address to determine
who new primary master is.

Format
config stacking force_master_role state [enable | disable]
 Parameters

Restrictions
Only Administrator, Operator and Power-User level users can issue this command.

Example
To enable stacking force master role state:
76.3. show stacking_mode

Description
This command displays the current stacking mode.

Format
show stacking_mode
 Parameters
None.
enable Specifies that the Switch's Stacking Force Master Role state will be enabled.
disable Specifies that the Switch's Stacking Force Master Role state will be disabled.
Zxxx0:admin# config stacking force_master_role state enable
Command: config stacking force_master_role state enable
Success.
Zxxx0:admin#