Panasonic ZEQUO 6400, Operating Instructions Manual

Page: 927 / 1058

84. Utility Commands
928
84.1. download

Description
This command is used to download a new firmware or a Switching Hub configuration
file.

Format
download [firmware_fromTFTP [<ipaddr> | <ipv6addr> | <domain_name 255>] src_file
<path_filename 64> {[unit <unit_id 1-4> | all]} {dest_file <pathname>} {boot_up} |
cfg_fromTFTP [<ipaddr> | <ipv6addr> | <domain_name 255>] src_file <path_filename
64> {[unit <unit_id 1-4> | all]} {[increment | dest_file <pathname>]}]

Parameters
show rcp server
ping [<ipaddr> | <domain_name 255>] {times <value 1-255> | timeout <sec 1-99> | source_ip
<ipaddr>}
ping6 <ipv6addr> {times <value 1-255> | size <value 1-6000> | timeout <sec 1-99> | source_ip
<ipv6addr>}
traceroute [<ipaddr> | <domain_name 255>] {ttl <value 1-60> | port <value 30000-64900> |
timeout <sec 1-65535> | probe <value 1-9>}
traceroute6 <ipv6addr> {ttl <value 1-60> | port <value 30000-64900> | timeout <sec 1-65535> |
probe <value 1-9>}
telnet [<ipaddr> | <domain_name 255> | <ipv6addr>] {tcp_port <value 1-65535>}
enable broadcast_ping_reply
disable broadcast_ping_reply
show broadcast_ping_reply
firmware_fromTFTP
Download and install new firmware on the Switching Hub from a TFTP server.
<ipaddr>
Specify the IP address of the TFTP server.
<ipv6addr>
Specify the IPv6 address of the TFTP server.
<domain_name 255>
Specifies the domain name of the TFTP server. This name can be up to 255
characters long.
src_file Specify the path name and file name of the TFTP server. It can be a relative path name or
an absolute path name. If path name is not specified, it refers to the TFTP server path.
The maximum length is 64 characters.
<path_filename 64>
Specify the path name and file name of the TFTP server. It can be a relative path
name or an absolute path name. If path name is not specified, it refers to the TFTP
server path. The maximum length is 64 characters.
unit Specifies which unit on the stacking system. If it is not specified, it refers to the master
unit.
<unit_id 1-4>Enter the unit ID used here.
all
Specifies that all the units in the stacking system will be used.