Panasonic ZEQUO 6400, Operating Instructions Manual

Page: 646 / 1058

59. Open Shortest Path First (OSPF) Command List
647
59.1. config ospf

Description
This command is used to configure the OSPF interface settings.
 Format
config ospf [ipif <ipif_name 12> | all] {area <area_id> | priority <value> | hello_interval <sec
1-65535> | dead_interval <sec 1-65535> | authentication [none | simple <password 8>] |
metric <value 1-65535> | state [enable | disable] | passive [enable | disable]}(1)
 Parameters
show ospf area {<area_id>}
create ospf host_route <ipaddr> {area <area_id> | metric <value 1-65535>}
config ospf host_route <ipaddr> {area <area_id> | metric <value 1-65535>}(1)
delete ospf host_route <ipaddr>
show ospf host_route {<ipaddr>}
config ospf router_id <ipaddr>
create ospf virtual_link <area_id> <neighbor_id> {hello_interval <sec 1-65535> | dead_interval
<sec 1-65535> | authentication [none | simple <password 8>]}
config ospf virtual_link <area_id> <neighbor_id> {hello_interval <sec 1-65535> | dead_interval
<sec 1-65535> | authentication [none | simple <password 8>]}(1)
delete ospf virtual_link <area_id> <neighbor_id>
show ospf virtual_link {<area_id> <neighbor_id>}
enable ospf
show ospf {[ipif <ipif_name 12> | all]}
disable ospf
show ospf lsdb {area <area_id> | advertise_router <ipaddr> | type [rtrlink | netlink | summary |
assummary | asextlink | nssa_ext | stub]}
show ospf neighbor {<ipaddr>}
show ospf virtual_neighbor {<area_id> <neighbor_id>}
ipif Specifies the name of the IP interface.
<ipif_name 12>
Enter the IP interface name here. This name can be up to 12 characters long.
all Specifies that all the IP interfaces will be used.
area (Optional) Specifies the area to which the interface is assigned. An Area ID is a 32-bit
number in the form of an IP address (xxx.xxx.xxx.xxx) that uniquely identifies the OSPF
area in the OSPF domain.
<area_id>
Enter the area ID used here.
priority (Optional) Specifies the priority value for the Designated Router election. If a Router
Priority of 0 is set, the Switch cannot be elected as the DR for the network.
<value>
Enter the priority value used here.