Panasonic ZEQUO 6400, Operating Instructions Manual

Page: 675 / 1058

60. OSPFv3 Commands
676
60.4. config ospfv3 router_id
 Description
This command is used to configure the OSPFv3 router ID.

Format
config ospfv3 router_id <ipaddr>

Parameters
Zxxx0:admin# show ospfv3 all
Command: show ospfv3 all
Interface Name: System Link Local Address: FE80::201:2FF:FE03:400
(Link Up)
Network Medium Type: BROADCAST Metric: 10
Area ID: 0.0.0.0 Administrative State: Disabled
Priority: 1 DR State: DOWN
DR ID: None Backup DR ID: None
Hello Interval: 10 Dead Interval: 40
Transmit Delay: 1 Retransmit Time: 5
Passive Mode: Disabled Instance ID: 0
Total Entries: 1
Zxxx0:admin# show ospfv3 ipif System
Command: show ospfv3 ipif System
Interface Name: System Link Local Address: FE80::201:2FF:FE03:400
(Link Up)
Network Medium Type: BROADCAST Metric: 10
Area ID: 0.0.0.0 Administrative State: Disabled
Priority: 1 DR State: DOWN
DR ID: None Backup DR ID: None
Hello Interval: 10 Dead Interval: 40
Transmit Delay: 1 Retransmit Time: 5
Passive Mode: Disabled Instance ID: 0
Total Entries: 1
Zxxx0:admin#
<ipaddr>Specifies that the user may enter a 32-bit number in the form of an IPv4 address that
uniquely identifies the router in the OSPFv3 domain. Setting it to be 0.0.0.0 means auto-
selected. The Switch will select the largest IPv4 address among the IP interfaces to be the
router ID. The default for the OSPFv3 router ID is 0.0.0.0 (auto-selected). Only by
executing this command, can the OSPFv3 router ID be changed.