Panasonic ZEQUO 6400, Operating Instructions Manual

Page: 691 / 1058

60. OSPFv3 Commands
692
60.18. config ospfv3 virtual_link
 Description
This command is used to configure an OSPFv3 virtual link.

Format
config ospfv3 virtual_link <area_id> <neighbor_id> {hello_interval <sec 1-65535> |
dead_interval <sec 1-65535> | instance <value 0-255>}

Parameters
 Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Zxxx0:admin# create ospfv3 virtual_link 1.1.1.1 60.60.60.60
Command: create ospfv3 virtual_link 1.1.1.1 60.60.60.60
Success.
Zxxx0:admin#
<area_id>Specifies a 32-bit number in the form of an IPv4 address that uniquely identifies the
OSPFv3 area in the OSPFv3 domain. This area is the transit area where the virtual link is
built.
<neighbor_id>
Specifies a 32-bit number in the form of an IPv4 address that uniquely identifies the
OSPFv3 virtual neighbor in the OSPFv3 domain.
hello_interval
(Optional) Specifies to allow the specification of the interval between the transmission of
OSPFv3 Hello packets. The Hello Interval and Dead Interval should be the same for all
routers on the same link.
<sec 1-65535>
Enter the hello interval value used here. This value must be between 1 and 65535
seconds. The default value is 10 seconds.
dead_interval
(Optional) Specifies to allow the specification of the length of time between the receipt of
Hello packets from a neighbor router before the selected area declares that router down.
The Dead Interval must be evenly divisible by the Hello Interval
<sec 1-65535>
Enter the dead interval value used here. This value must be between 1 and 65535
seconds. The default value is 60 seconds.
instance (Optional) Specifies the instance ID on the virtual link.
<value 0-255>
Enter the instance ID value here. This value must be between 0 and 255. The
default value is 0.