Panasonic ZEQUO 6400, Operating Instructions Manual

Page: 960 / 1058

85. Virtual Router Redundancy Protocol (VRRP) Command List
961

Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
 Example
To configure VRRP:
preempt (Optional) Controls whether a higher priority virtual router will preempt a lower priority
master. The preempt setting must be consistent with all the routers participating within
the same VRRP group. Default is settings is true.
true Specifies that if the backup router's priority is set higher than the masters priority, it
will become the master instead of the current one.
false Specifies that if the backup router's priority is higher than the masters priority, it will
not become the master until the master failed.
critical_ip
(Optional) specifies an IP address that will provide the most direct route to the Internet or
other critical network connections from this virtual router. This IP address must be a real
IP address of a real device on the network. If the connection from the virtual router to this
IP address fails, the virtual router will automatically be disabled. A new Master will be
elected from the backup routers participating in the VRRP group. Different critical IP
addresses may be assigned to different routers participating in the VRRP group and can
therefore define multiple routes to the Internet or other critical network connections.
<ipaddr>
Enter the critical interface's IP address used here.
critical_ip_state
(Optional) Specifies the state of checking the status (active or inactive) of a critical IP
address.
enable
Specifies that the critical IP state checking will be enabled.
disable
Specifies that the critical IP state checking will be disabled.
Zxxx0:admin# config vrrp vrid 1 ipif System state enable
Command: config vrrp vrid 1 ipif System state enable
Success.
Zxxx0:admin#