Panasonic ZEQUO 6400, Operating Instructions Manual

Page: 463 / 1058

40. IPv6 NDP Commands
464
40.5. config ipv6 nd ra ipif
 Description
This command is used to configure the RA parameters of a specified interface.

Format
config ipv6 nd ra ipif <ipif_name 12> {state [enable | disable] | life_time <sec 0-9000> |
reachable_time <millisecond 0-3600000> | retrans_time <millisecond 0-4294967295> |
hop_limit <value 0-255> | managed_flag [enable | disable] | other_config_flag [enable
| disable] | min_rtr_adv_interval <sec 3-1350> | max_rtr_adv_interval <sec 4-1800>}(1)

Parameters
<ipif_name 12>
Specify the interface's name.
state Specify the router advertisement status.
enable
Enable the router advertisement state.
disable
Disable the router advertisement state.
life_time Specify the lifetime of the router as the default router, in seconds.
<sec 0-9000>
Specify the time between 0 and 9000 seconds.
reachable_time
Specifies the amount of time that a node can consider a neighboring node reachable
after receiving a reachability confirmation in millisecond.
<millisecond 0-3600000>
Specify the time between 0 and 3600000 milliseconds.
retrans_time
Specifies the amount of time between retransmissions of router advertisement message
in millisecond, and the router advertisement packet will take it to host.
<millisecond 0-4294967295>
Specify the time between 0 and 4294967295 milliseconds.
hop_limit
Specify the default value of the hop limit field in the IPv6 header for packets sent by hosts
that receive this RA message.
<value 0-255>
Specify the value between 0 and 255.
managed_flag
Specify to enable or disable the function.
enable
When set to enable, it indicates that hosts receiving this RA must use a stateful
address configuration protocol to obtain an address, in addition to the addresses
derived from the stateless address configuration.
disable
Set to disable to stop hosts receiving the RA from using a stateful address
configuration to obtain an address.