Panasonic ZEQUO 6400, Operating Instructions Manual

Page: 217 / 1058

20. Debug Software Command List
218
20.Debug Software Command List
The commands are used to configure the monitoring and logging of
protocol communication status and how to handle when an error occurs.
The following protocols are supported, as well as general protocols.
 VRRP (Virtual Router Redundancy Protocol), which multiplexes a router or L3 Switching
Hub
 STP (Spanning Tree Protocol), which prevents loops and provides redundancy

OSPF (Open Shortest Path First), which provides routing
 DHCPv6 relay and server

PIM-SSM, which provides multicast routing
debug error_log [dump | clear | upload_toTFTP <ipaddr> <path_filename 64>]
debug buffer [utilization | dump | clear | upload_toTFTP <ipaddr> <path_filename 64>]
debug output [module <module_list> | all] [buffer | console]
debug config error_reboot [enable | disable]
debug config state [enable | disable]
debug show error_reboot state
debug stp clear counter {ports [<portlist> | all]}
debug stp config ports [<portlist> | all] [event | bpdu | state_machine | all] state [disable | brief |
detail]
debug stp show counter {ports [<portlist> | all]}
debug stp show flag {ports <portlist>}
debug stp show information
debug stp state [disable | enable]
debug ospf [neighbor_state_change | interface_state_change {dr_bdr_selection} | lsa {all |
originating | installing | receiving | flooding} (1) | packet {all | receiving | sending} (1) |
retransmission | spf {all | intra | inter | extern} (1) | timer | virtual_link | route |
redistribution] state [enable | disable]
debug ospf clear counter {packet | neighbor | spf}
debug ospf log state [enable | disable]
debug ospf show counter {packet | neighbor | spf}
debug ospf show detail external_link
debug ospf show detail net_link
debug ospf show detail rt_link
debug ospf show detail summary_link
debug ospf show detail type7_link
debug ospf show flag
debug ospf show log state
debug ospf show redistribution
debug ospf show request_list
debug ospf show summary_list
debug ospf state [enable | disable]
debug vrrp [vr_state_change | packet [all | {receiving | sending}(1)] | mac_addr_update |
interface_change | timers] state [enable | disable]
debug vrrp clear counter
debug vrrp log state [enable | disable]
debug vrrp show counter