12. Basic IP Commands
168
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To display the link local address automatic configuration state:
12.10. enable ip_setup_interface
Description
This command is used to enable the IP setup interface function. The factory default
status is enabled.
This function provides easy-to-use IP address setting via our application “ZEQUO
assist”. If this function is enabled, ZEQUO asssit can find this Switching Hubs in the
same network segment and can configure each IP address. For security reason, the IP
address setting is allowed for 20 minutes from boot-up except factory default setting.
Format
enable ip_setup_interface
Parameters
None
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To enable the IP setup interface function:
Zxxx0:admin#show ipif_ipv6_link_local_auto
Command: show ipif_ipv6_link_local_auto
IPIF: System Automatic Link Local Address: Disabled
Zxxx0:admin#
Zxxx0:admin#enable ip_setup_interface
Command: enable ip_setup_interface
Success.
Zxxx0:admin#
Summary of Contents for ZEQUO 6400
