Panasonic ZEQUO 6400, Operating Instructions Manual

Page: 696 / 1058

61. Packet Storm Commands
697
61.1. config traffic control
 Description
This command is used to configure broadcast/multicast/unicast storm control. The
broadcast storm control commands provide a hardware storm control mechanism only.
These packet storm control commands include hardware and software mechanisms to
provide shutdown, recovery, and trap notification functions.

Format
config traffic control [<portlist> | all] {broadcast [enable | disable] | multicast [enable |
disable] | unicast [enable | disable] | action [drop | shutdown] | threshold <value 0-
255000> | countdown [<min 0> | <min 3-30> | disable] | time_interval <sec 5-600>}(1)
 Parameters
<portlist>Specify a range of ports to be configured.
all Specify all ports are to be configured.
broadcast
Specify the broadcast storm status.
enable
Enable broadcast storm control.
disable
Disable broadcast storm control.
multicast
Specify the multicast storm status.
enable
Enable multicast storm control.
disable
Disable multicast storm control.
unicast Specify the unknown unicast packet storm status.
enable
Enable unknown unicast packet storm control (only support drop action).
disable
Disable unknown unicast packet storm control.
action Specify the action.
drop Drop the packet by hardware when it is detected threthold.
shutdown
Shutdown the port by software when it is detected threthold. If this is chosen,
threshold, countdown, and time_interval also need to be configured.
threshold
The upper threshold at which the specified storm control will turn on.
This is the number of broadcast/multicast/unknown unicast packets per second received
by the Switching Hub that will trigger the storm traffic control measure. It must be an
unsigned integer.
<value 0-255000>
Specify the value between 0 and 255000.