34. Internet Group Management Protocol (IGMP) Commands
402
To show the status of the check subscriber for the received IGMP report/leave
messages on all interfaces:
34.6. create igmp static_group ipif
Description
This command is used to create an IGMP static group on the Switch.
Format
create igmp static_group ipif <ipif_name 12> group <ipaddr>
Parameters
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To create an IGMP static group, with the multicast IP address 225.0.0.2 on the IP
interface "System":
Zxxx0:admin# show igmp check_subscriber_source_network
Command: show igmp check_subscriber_source_network
Interface IP Address/Netmask Check Subscriber Source Network
------------ ------------------ -------------------------------
System 10.90.90.90/8 Enabled
n1 1.1.1.1/8 Disabled
n11 11.1.1.1/8 Disabled
n20 20.1.1.1/8 Disabled
n100 100.3.2.2/8 Disabled
Total Entries: 5
Zxxx0:admin#
ipif
Specifies the IP interface name used for this configuration.
<ipif_name 12>
Enter the IP interface name used for this configuration here. This name can be up
to 12 characters long.
group
Specifies the multicast IP address used.
<ipaddr>
Enter the multicast IP address used here.
Zxxx0:admin# create igmp static_group ipif System group 225.0.0.2
Command: create igmp static_group ipif System group 225.0.0.2
Success.
Zxxx0:admin#
Summary of Contents for ZEQUO 6400
