Panasonic ZEQUO 6400, Operating Instructions Manual

Page: 23 / 1058

4. Using Command Line Interface
24
There is no initial username or password. Just press the Enter key twice to display the CLI
input cursor - Zxxx0:admin#. This is the command line where all commands are input.
4.2. Setting the Switch's IP Address
Each Switch must be assigned its own IP Address, which is used for communication with
an SNMP network manager or other TCP/IP application (for example BOOTP, TFTP). The
Switch's default IP address is 10.90.90.90. You can change the default Switch IP address to
meet the specification of your networking address scheme.
The Switch is also assigned a unique MAC address by the factory. This MAC address cannot
be changed, and can be found on the initial boot console screen - shown below or the
command show switch.
The Switch's MAC address can also be found in the Web management program on the
Device Information (Basic Settings) window on the Configuration menu.
The IP address for the Switch must be set before it can be managed with the Web-based
manager. The Switch IP address can be automatically set using BOOTP or DHCP protocols,
in which case the actual address assigned to the Switch must be known.
Starting at the command line prompt, enter the commands config ipif System ipaddress
xxx.xxx.xxx.xxx/yyy.yyy.yyy.yyy. Where the x's represent the IP address to be assigned to the
IP interface named System and the y's represent the corresponding subnet mask.
Alternatively, you can enter config ipif System ipaddress xxx.xxx.xxx.xxx/z. Where the x's
represent the IP address to be assigned to the IP interface named System and the z
represents the corresponding number of subnets in CIDR notation.
The IP interface named System on the Switch can be assigned an IP address and subnet
mask which can then be used to connect a management station to the Switch's Telnet or
Web-based management agent
Boot Procedure V1.0.x.xx
-------------------------------------------------------------------------------
Power On Self Test ........................................ 100 %
MAC Address : 00-01-02-03-04-00
H/W Version : A1
Please Wait, Loading V1.0.0.xx Runtime Image .............. 100 %
UART init ................................................. 100 %
Starting runtime image
Device Discovery .......................................... 100 %
Configuration init ........................................ 100 %
Zxxx0:admin# config ipif System ipaddress 10.24.22.100/255.0.0.0
Command: config ipif System ipaddress 10.24.22.100/8
Success.
Zxxx0:admin#