Panasonic ZEQUO 6400, Operating Instructions Manual

Page: 407 / 1058

35. IGMP Proxy Commands
408
35.4. config igmp_proxy upstream_if
 Description
This command is used to configure the setting for the IGMP proxy's upstream
interface. The IGMP proxy plays the host role on the upstream interface. It will send
IGMP report packets to the router port.
The source IP address determines the source IP address to be encoded in the IGMP
protocol packet.
If the router port is empty, the upstream will send the IGMP protocol packet to all
member ports on the upstream interface.

Format
config igmp_proxy upstream_if {vlan [<vlan_name 32> | vlanid <vlanid 1-4094>] |
router_ports [add | delete] <portlist> | source_ip <ipaddr> |
unsolicited_report_interval <sec 0-25>} (1)

Parameters

Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
vlan Specify the VLAN for the upstream interface.
<vlan_name 32>
Specify a VLAN name between 1 and 32 characters.
vlanidSpecify the VLAN ID for the upstream interface.
<1-4094>
Specify the VLAN ID between 1 and 4094.
router_ports
Specify a list of ports that are connected to multicast-enabled routers.
add
Specify to add the router ports.
deleteSpecify to delete the router ports.
<portlist>
Specify a range of ports to be configured.
source_ip
Specify the source IP address of the upstream protocol packet. If it is not specified, zero
IP address will be used as the protocol source IP address.
<ipaddr>
Specify the IP address.
unsolicited_report_interval
Specify the time between repetitions of the host's initial report of membership in a group.
The default is 10 seconds. If set to 0, only one report packet is sent.
<sec 0-25>
Specify the time between 0 and 25 seconds.