Panasonic ZEQUO 6400, Operating Instructions Manual

Page: 436 / 1058

38. IP Routing Commands
437
38.1. create iproute
 Description
This command is used to create an IP route entry in the Switching Hub's IP routing
table. This command creates an IP route entry in the Switching Hub's IP routing table.
"Primary" and "backup" are mutually exclusive. Users can select only one when
creating one new route. If a user sets neither of these, the system will try to set the
new route first by primary and second by backup and not set this route to be a
multipath route.

Format
create iproute [default | <network_address>] [null0 | <ipaddr> {<metric 1-65535>}
{[primary | backup | weight <value 1-4>]} | ip_tunnel <tunnel_name 12>]

Parameters

Restrictions
Only Administrator, Operator and Power-User level users can issue this command.

Example
To add a default route with a nexthop of 10.48.74.21:
default Create a default IP route entry.
<network_address>
The IP address and netmask of the IP interface that is the destination of the route. Specify
the address and mask information using the traditional format (for example, 10.1.2.3/
255.0.0.0 or in CIDR format, 10.1.2.3/16).
null0 Specifies the null interface as the next hop.
<ipaddr>Specify the IP address for the next hop router.
<metric 1-65535>
(Optional) The default setting is 1.That is, the default hop cost is 1.
primary
(Optional) Specifies the route as the primary route to the destination.
backup
(Optional) Specifies the route as the backup route to the destination. If the route is
not specified as the primary route or the backup route, then it will be auto-assigned
by the system. The first created is the primary, the second created is the backup.
weight
(Optional) Specifies the weight value of the IP route.
<value 1-4>
Enter the weight value used here. This value must be between 1 and 4.
ip_tunnel
Specifies the IP tunnel used.
<tunnel_name 12>
Enter the IP tunnel name used here. This name can be up to 12 characters long.